How long Stake withdrawals take

For crypto, Stake withdrawals are widely reported to arrive within minutes in the usual case, and the time you see is mostly the blockchain rather than Stake. The honest range is wide: from a few minutes on a fast network to an hour or more on a congested one, and longer when the request is held for a review or an identity check. Stake does not promise a fixed time, so no page, including this one, can either.

Three things decide your wait. First, whether your account has cleared the checks Stake applies to withdrawals, covered in our KYC verification guide. Second, the coin and network you choose, because a Litecoin or Tron transfer confirms far faster than a busy Bitcoin one. Third, what happens at the receiving end, since an exchange may hold incoming deposits until it has enough confirmations.

If a withdrawal is stuck in a pending state, jump to our pending withdrawal guide. The rest of this page explains each stage so you can tell a normal wait from a problem. 18+ only.

A withdrawal passes through the same stages whatever coin you use.

1. You submit the request in Wallet, then Withdraw, choosing the coin, the address and the amount. Two-factor authentication is usually asked for at this point.
2. Stake runs its checks. Automated checks look at the account, the amount and the destination. Most routine requests clear without a human. Larger or unusual ones, or requests on an account with open verification steps, can be held for manual review.
3. The transaction is broadcast to the blockchain from Stake's wallet. You get a transaction ID that you can paste into a block explorer.
4. The network confirms it. Time depends on the chain. This stage is outside Stake's control.
5. The receiving wallet or exchange credits it. An exchange may wait for several confirmations before showing a balance.

When people say a withdrawal is slow, it is usually stage 2 or stage 5. A transaction ID in the history means stage 3 has happened, and everything after that is on-chain or at the destination.

The common causes, from most to least frequent:

• Verification not finished. If Stake has asked for documents and you have not completed them, the request can wait. Finishing the check is the only fix, as explained in Stake KYC verification.
• Network congestion. Bitcoin and Ethereum fees spike when demand is high. If the fee attached to your transfer is low, it can wait in the mempool.
• Exchange hold on the incoming deposit. Many exchanges wait for a set number of confirmations, and some hold new deposits from gambling-related addresses for review.
• Large amounts. Big withdrawals draw more scrutiny and may be reviewed manually, see withdrawal limits.
• Bonus or wagering conditions. If a promotion has terms that are not yet met, the withdrawal can be refused or held. Read the terms of any offer you took.
• Wrong network or address mistakes. These do not slow the withdrawal so much as send it to the wrong place, which is a different problem.
• Service issues. Occasionally Stake or a coin's wallet is under maintenance. Check whether Stake is down.

Start with the transaction ID. If the withdrawal history shows one, paste it into the block explorer for that coin. Unconfirmed means the network has not mined it yet. Confirmed with several confirmations means the coins have arrived at the address and any further delay is at the destination, so check the receiving wallet or ask the exchange.

If there is no transaction ID after what feels like a long time, check the status shown in your history and any email from Stake asking for documents. Reply promptly and completely, because partial answers restart the clock. Contact support once, with the request details, rather than opening several tickets, which tends to slow things down.

Do not repeat the withdrawal in the hope it speeds things up. A duplicate request can lock up more of your balance without helping the first.

You cannot force Stake to be faster, but you can remove the usual obstacles.

• Complete verification early, before you have a balance you want to cash out. It is the biggest single time-saver.
• Choose a fast, cheap network such as Litecoin or USDT on Tron when your destination supports it. Check the address format first, because sending a coin on the wrong network is the costliest mistake.
• Withdraw to a wallet you control if the exchange is slow to credit, then decide what to do next.
• Match the coin to your balance. Stake holds a balance per coin, so withdrawing in the same coin you hold avoids an extra step.
• Keep two-factor authentication on and your email current, because security prompts and document requests arrive there.
• Avoid peak hours for slow chains when a network is congested.